Discourse/Guilds Laser/2019-03-30 Stenciling with the Laser

From Noisebridge
Jump to navigation Jump to search

📜 Discourse Archive
This page is preserved verbatim from discuss.noisebridge.info, the Noisebridge community forum that operated roughly 2018–2022. The original site is defunct; this content was recovered via the Wayback Machine and is archived here as a primary source for Noisebridge history.
⮡ Original URL: https://discuss.noisebridge.info/t/stenciling-with-the-laser/455
📦 Verify on Wayback Machine
📅 Archived: 2021-01-21
🏷 Original category: Guilds_Laser

Stenciling with the Laser[edit | edit source]

Bengraneygreen

Hey all, anyone done laser cutting to create spray stencils? Was thinking of using thick-ish paper settings to cut blue painters tape. Seen on forums people use this as an anti-scorch layer so i assume it’s safe to cut.

Also, side note - I lost the password to the computer but I got trained and my name is in the trained section on the wiki. Am lost pls help


nthmost — 2019-03-30

absolutely, yo.

You can get away with pretty thin acetate for this purpose. Cardboard works very well too.

Those exclamation mark looking things in the far back classroom on the wall were done with an experimental stencil I made on the laser cutter, cut on cardboard.


Bengraneygreen — 2019-03-30

Nice! I’ll post any results i get

Retrieved from "https://wiki.extremist.software/index.php?title=Discourse/Guilds_Laser/2019-03-30_Stenciling_with_the_Laser&oldid=89040"