Discourse/General/2019-01-23 Laser Cutting Supplies

📜 Discourse Archive This page is preserved verbatim from discuss.noisebridge.info, the Noisebridge community forum that operated roughly 2018–2022. The original site is defunct; this content was recovered via the Wayback Machine and is archived here as a primary source for Noisebridge history. ⮡ Original URL: https://discuss.noisebridge.info/t/laser-cutting-supplies/119 📦 Verify on Wayback Machine 📅 Archived: 2022-05-19 🏷 Original category: General

Laser Cutting Supplies

---

tdfischer — 2019-01-23

Hey, we seem to be all out of thin plywood for use on the laser cutter. Can Noisebridge buy a big pile of it? I need some for the new 5mof podium design I’m putting together, but don’t want to spend a bunch of money for a 16"x16" square out of a 4’x8’ sheet.

---

---

gaardn — 2019-01-23

Absolutely! Someone will need to go pick it up, then post the receipt to #finance-wg for reimbursement.

I’ve done this before at Discount Builders by purchasing ten sheets of 6mm birch for ~$30/ea.

They’re 96" long, so I had Discount Builders chop them in thirds, then loaded in my car and asked for help bringing them to Noisebridge.

---

---

mcscope — 2019-01-23

If you look around at Discount Builder, they have smaller sheets too.

---