Maker Faire Build Night 2015-04-16
This is part of the Noisebridge Booth for Maker Fair 2015 project
The project continues.
So this recap covers more that just the single build night. This being the case, we have a good variety of progress to show. We put more parts on the table, started the electrical wiring, and started on the flashy blinky lights!
We added the third side of each leg using biscuit joinery and hella clamps. These new panels are the parts of the legs that will host the outlet boxes in the legs, as shown later
Here are all the third sides of the legs attached. The fourth and final side of each leg will go on once the outlets and electronics are wired up and well tested.
We added a small strip of plwood to the leg to act as a mount for the outlet boxes. This was installed wth pocket holes and glue and was placed so that the outlet boxes are held off a little way from the face of the table legs.
TEXT
TEXT
TEXT
TEXT
TEXT
TEXT