Obleo: This is the form of the finished Dopplers. Radar board mounts inside. Height, with bracket is 5". Bracket is setup to permit direct mounting to bamboo (Guadua) primary vertical supports for tower. Doppler's best placement will likely be on outside ...

2013-07-18T04:25:06Z

New page

This is the form of the finished Dopplers. Radar board mounts inside. Height, with bracket is 5". Bracket is setup to permit direct mounting to bamboo (Guadua) primary vertical supports for tower. Doppler's best placement will likely be on outside of bamboo supports, pointing to ground, parallel to the support. Sensing cone is approximately 90 degrees, so a 4 meter high placement, on support, will sense up to an 8 meter area (cone base), with Doppler at vertex of cone.

All Dopplers will have a RJ45 cable linking power and analog signal from a host junction box placed on one of the supports. Primary 5VDC and GND applied to junction box for distribution. All analog signals accessible from junction box via DSUB 37 pin male or female connector.

File:Finished Doppler Can.JPG - Revision history

Obleo: This is the form of the finished Dopplers. Radar board mounts inside. Height, with bracket is 5". Bracket is setup to permit direct mounting to bamboo (Guadua) primary vertical supports for tower. Doppler's best placement will likely be on outside ...